CWS Impact Garage Doors Nationwide | Sightline Windows & Doors Kendall

CWS Impact Garage Doors: The Kendall Owner’s Guide

CWS impact garage door replacement in Kendall typically runs $2,800-$5,400 installed, depending on door size, wind-load rating, and hardware series. We stock CWS-compatible panels, torsion systems, and track hardware for same-day installation on most residential sizes. Most Kendall owners discover a problem when the door hangs crooked after a storm, the opener strains against a warped panel, or they notice daylight leaking through a cracked impact skin that passed the visible test but failed structurally.

Call (786) 321-3319

Which CWS Models This Applies To

CWS builds impact garage doors across several series, and the parts are not interchangeable between lines. The CWS 900 Series and 1100 Series are the two most common in Kendall homes built between 2015 and 2022, identifiable by the silver CWS label on the interior track bracket and the four-digit model stamp on the top panel edge. The 900 Series uses a 2-inch track with 15-gauge steel; the 1100 Series steps up to a 2.5-inch track and 14-gauge hardware, which matters if you’re replacing bent verticals after a close-call hurricane season.

OEM CWS panels and hardware are available through regional distribution, but lead times stretch 10-14 days during South Florida’s pre-season rush. We also source Florida Product Approved aftermarket equivalents from our verified lines - same Miami-Dade and Broward impact ratings, same wind-load certificates, often at a shorter lead. The catch: mixing a 900 Series panel with 1100 Series track hardware throws off the roller spacing and stresses the opener. We verify series match on every CWS job before ordering. If your label is faded, we measure track gauge and roller spacing on-site - part of the measured survey you keep.

Signs Your CWS Impact Garage Door Is Failing

• The door binds or reverses mid-travel. CWS impact doors are heavy - often 180-240 pounds on a double-car opening. When the torsion spring loses tension (typically 8-12 years in Kendall’s salt-air environment), the opener motor detects the strain and auto-reverses. The spring is the failure, not the opener.
• Visible cracking or delamination on the impact skin. CWS doors use a fiberglass or aluminum skin bonded to a foam core. Once that bond separates, the door loses its impact rating even if it still looks intact. We see this most on west-facing doors in Kendall, where afternoon thermal cycling accelerates adhesive fatigue.
• Roller noise that wasn’t there last season. CWS nylon rollers degrade in UV and humidity. When they flatten or crack, steel-on-steel contact begins. The repair is straightforward - 2-inch or 2.5-inch roller swap depending on series - but running it long enough damages the track itself.
• Daylight visible around the perimeter seal. The rubber bulb seal on a CWS door compresses permanently after 5-7 years. In Kendall, that means water intrusion during our summer storms and conditioned air loss year-round. The seal is a $40 part; the energy cost of ignoring it adds up fast.
• The door sits unevenly in the frame. CWS doors rely on cable tension balance. When a cable frays or a drum slips, one side drops. Left uncorrected, the panel edges scrape the jamb and the opener rail torques out of plumb. We check cable condition on every service call - it’s a 30-second read that prevents a $1,200 panel replacement.

Before

After

Replacement Cost & What’s Included

Full CWS impact garage door replacement in Kendall runs $2,800-$4,200 for a single-car opening and $3,800-$5,400 for double-car, installed. That includes the door, track hardware, torsion spring system, rollers, and weather seal - plus haul-away of the old unit. Prices at the higher end reflect 1100 Series upgrades, custom panel finishes, or wind-load ratings above the standard 140 mph Miami-Dade requirement.

Component-level repairs cost less: torsion spring replacement typically $280-$420, roller set $180-$260, cable and drum service $220-$340. We itemize every line on the written quote you receive before work starts - Haven Clause 1. The 365-Day Done Right Promise covers labor and installation; manufacturer defects route through CWS’s own warranty, which we handle as part of the job.

DIY or Call Us?

There’s safe checking, and then there’s work that belongs to a trained technician. A homeowner can verify the CWS series label, listen for roller noise, and spot visible skin damage - that’s useful information to share when you call. What we don’t recommend: adjusting or replacing torsion springs. These are under extreme tension; an uncontrolled release causes serious injury and has killed experienced DIYers. The same applies to cable drum work - the stored energy in a loaded system doesn’t forgive a slipped wrench.

We carry CWS-compatible springs, cables, rollers, and seals on our service trucks. Most component replacements in Kendall take 2-3 hours; full door swaps run a full day including removal, frame prep, and operational testing. Every visit leaves you with a documented photo record and the measured survey. Call (786) 321-3319 to schedule - estimates are free, and the price we write is the price you pay.

FAQs